Cisco IOS 12.0xv

HTTP server for Cisco IOS 11.3 to 12.2 allows attackers to bypass authentication and execute arbitrary commands, when local authorization is being used, by specifying a high access level in the URL.

Stack-based buffer overflow in the Line Printer Daemon (LPD) in Cisco IOS before 12.2(18)SXF11, 12.4(16a), and 12.4(2)T6 allow remote attackers to execute arbitrary code by setting a long hostname on the target system, then causing an error message to be printed, as demonstrated by a telnet session to the LPD from a source port other than 515.

Cisco IOS 12.0 to 12.4 might allow remote attackers to execute arbitrary code via a heap-based buffer overflow in system timers. NOTE: this issue does not correspond to a specific vulnerability, rather a general weakness that only increases the feasibility of exploitation of any vulnerabilities that might exist. Such design-level weaknesses normally are not included in CVE, so perhaps this issue should be REJECTed.

Cisco IOS 11.x and 12.0 through 12.2 allows remote attackers to cause a denial of service (traffic block) by sending a particular sequence of IPv4 packets to an interface on the device, causing the input queue on that interface to be marked as full.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4 allows remote attackers to cause a denial of service (device reload) via a crafted Protocol Independent Multicast (PIM) packet.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when SIP voice services are enabled, allows remote attackers to cause a denial of service (device crash) via a valid SIP message.

Unspecified vulnerability in Cisco IOS 12.0 through 12.4, when configured with (1) IP Service Level Agreements (SLAs) Responder, (2) Session Initiation Protocol (SIP), (3) H.323 Annex E Call Signaling Transport, or (4) Media Gateway Control Protocol (MGCP) allows remote attackers to cause a denial of service (blocked input queue on the inbound interface) via a crafted UDP packet.

Buffer overflow in Cisco IOS 11.2.x to 12.0.x allows remote attackers to cause a denial of service and possibly execute commands via a large number of OSPF neighbor announcements.

Cisco IOS 12.0 through 12.2, when supporting SSH, allows remote attackers to cause a denial of service (CPU consumption) via a large packet that was designed to exploit the SSH CRC32 attack detection overflow (CVE-2001-0144).

Cisco IOS 12.0 through 12.4 on Gigabit Switch Router (GSR) devices (aka 12000 Series routers) allows remote attackers to cause a denial of service (device crash) via a malformed Protocol Independent Multicast (PIM) packet.

The (1) Cisco Unified Communications Manager Express; (2) SIP Gateway Signaling Support Over Transport Layer Security (TLS) Transport; (3) Secure Signaling and Media Encryption; (4) Blocks Extensible Exchange Protocol (BEEP); (5) Network Admission Control HTTP Authentication Proxy; (6) Per-user URL Redirect for EAPoUDP, Dot1x, and MAC Authentication Bypass; (7) Distributed Director with HTTP Redirects; and (8) TCP DNS features in Cisco IOS 12.0 through 12.4 do not properly handle IP sockets, which allows remote attackers to cause a denial of service (outage or resource consumption) via a series of crafted TCP packets.

Secure Shell (SSH) 2 in Cisco IOS 12.0 through 12.3 allows remote attackers to cause a denial of service (device reload) (1) via a username that contains a domain name when using a TACACS+ server to authenticate, (2) when a new SSH session is in the login phase and a currently logged in user issues a send command, or (3) when IOS is logging messages and an SSH session is terminated while the server is sending data.

Cisco IOS 12.0 through 12.4, when IP-based tunnels and the Cisco Express Forwarding feature are enabled, allows remote attackers to cause a denial of service (device reload) via malformed packets, aka Bug ID CSCsx70889.

Cisco IOS 12.0 through 12.4, when IP-based tunnels and the Cisco Express Forwarding feature are enabled, allows remote attackers to cause a denial of service (device reload) via a malformed packet that is not properly handled during switching from one tunnel to a second tunnel, aka Bug IDs CSCsh97579 and CSCsq31776.

The OSPF implementation in Cisco IOS 12.0 through 12.4 and 15.0 through 15.3, IOS-XE 2.x through 3.9.xS, ASA and PIX 7.x through 9.1, FWSM, NX-OS, and StarOS before 14.0.50488 does not properly validate Link State Advertisement (LSA) type 1 packets before performing operations on the LSA database, which allows remote attackers to cause a denial of service (routing disruption) or obtain sensitive packet information via a (1) unicast or (2) multicast packet, aka Bug IDs CSCug34485, CSCug34469, CSCug39762, CSCug63304, and CSCug39795.

Cisco IOS 12.0 through 12.3YL, with BGP enabled and running the bgp log-neighbor-changes command, allows remote attackers to cause a denial of service (device reload) via a malformed BGP packet.

Cisco VACM (View-based Access Control MIB) for Catalyst Operating Software (CatOS) 5.5 and 6.1 and IOS 12.0 and 12.1 allows remote attackers to read and modify device configuration via the read-write community string.

Multiple cross-site scripting (XSS) vulnerabilities in the HTTP server in Cisco IOS 11.0 through 12.4 allow remote attackers to inject arbitrary web script or HTML via (1) the query string to the ping program or (2) unspecified other aspects of the URI.