Cisco IOS Xe

Cisco IOS XE Software for Catalyst 9800 Series Wireless Controllers EoGRE Denial of Service Vulnerability

Cisco IOS XE Software Rate Limiting Network Address Translation Denial of Service Vulnerability

Cisco IOS XE Software Protection Against Distributed Denial of Service Attacks Feature Vulnerability

Cisco IOS XE Software for Catalyst 9000 Family Wireless Controllers CAPWAP Denial of Service Vulnerabilities

Cisco IOS XE Software IP Service Level Agreements Denial of Service Vulnerability

Cisco IOS XE Wireless Controller Software for the Catalyst 9000 Family CAPWAP Mobility Denial of Service Vulnerability

Cisco IOS and IOS XE Software Web Services Denial of Service Vulnerability

Cisco IOS XE Wireless Controller Software for the Catalyst 9000 Family DHCP Processing Denial of Service Vulnerability

Cisco IOS and IOS XE Software Common Industrial Protocol Request Denial of Service Vulnerability

A vulnerability in the implementation of the IPv4 fragmentation reassembly code in Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper management of resources during fragment reassembly. An attacker could exploit this vulnerability by sending specific sizes of fragmented packets to an affected device or through a Virtual Fragmentation Reassembly (VFR)-enabled interface on an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: This vulnerability affects Cisco ASR 1000 Series Aggregation Services Routers and Cisco cBR-8 Converged Broadband Routers if they are running Cisco IOS XE Software Release 17.12.1 or 17.12.1a.

Cisco IOS XE Software Fragmented Tunnel Protocol Packet Denial of Service Vulnerability

Cisco IOS XE Software Virtual Fragmentation Reassembly Denial of Service Vulnerability

Cisco IOS XE Software for Cisco cBR-8 Converged Broadband Routers Common Open Policy Service Denial of Service Vulnerability

Cisco IOS XE Software AppNav-XE Denial of Service Vulnerability

Cisco IOS XE Software DNS NAT Protocol Application Layer Gateway Denial of Service Vulnerability

Cisco IOS XE Software for Embedded Wireless Controllers on Catalyst 9100 Series Access Points UDP Processing Denial of Service Vulnerability

Cisco IOS XE Software for Catalyst Switches MPLS Denial of Service Vulnerability

A vulnerability in the HTTP Server feature of Cisco IOS XE Software when the Telephony Service feature is enabled could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to a null pointer dereference when accessing specific URLs. An attacker could exploit this vulnerability by sending crafted HTTP traffic to an affected device. A successful exploit could allow the attacker to cause the affected device to reload, causing a DoS condition on the affected device.

Cisco IOS XE Software Catalyst 9800 Series Wireless Controllers Denial of Service Vulnerability

A vulnerability in the DHCP snooping feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to a crafted IPv4 DHCP request packet being mishandled when endpoint analytics are enabled. An attacker could exploit this vulnerability by sending a crafted DHCP request through an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: The attack vector is listed as network because a DHCP relay anywhere on the network could allow exploits from networks other than the adjacent one.

A vulnerability in the IPv4 Software-Defined Access (SD-Access) fabric edge node feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause high CPU utilization and stop all traffic processing, resulting in a denial of service (DoS) condition on an affected device. This vulnerability is due to improper handling of certain IPv4 packets. An attacker could exploit this vulnerability by sending certain IPv4 packets to an affected device. A successful exploit could allow the attacker to cause the device to exhaust CPU resources and stop processing traffic, resulting in a DoS condition.

A vulnerability in the Locator ID Separation Protocol (LISP) feature of Cisco IOS Software and Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload. This vulnerability is due to the incorrect handling of LISP packets. An attacker could exploit this vulnerability by sending a crafted LISP packet to an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a denial of service (DoS) condition. Note: This vulnerability could be exploited over either IPv4 or IPv6 transport.

A vulnerability in Application Quality of Experience (AppQoE) and Unified Threat Defense (UTD) on Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to the mishandling of a crafted packet stream through the AppQoE or UTD application. An attacker could exploit this vulnerability by sending a crafted packet stream through an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

A vulnerability in the process that classifies traffic that is going to the Unified Threat Defense (UTD) component of Cisco IOS XE Software in controller mode could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability exists because UTD improperly handles certain packets as those packets egress an SD-WAN IPsec tunnel. An attacker could exploit this vulnerability by sending crafted traffic through an SD-WAN IPsec tunnel that is configured on an affected device. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition. Note: SD-WAN tunnels that are configured with Generic Routing Encapsulation (GRE) are not affected by this vulnerability.

A vulnerability in Cisco IOS XE Software for Cisco Catalyst 3650 and Catalyst 3850 Series Switches could allow an unauthenticated, remote attacker to cause an affected device to reload unexpectedly, resulting in a denial of service (DoS) condition. This vulnerability is due to improper resource management when processing traffic that is received on the management interface. An attacker could exploit this vulnerability by sending a high rate of traffic to the management interface. A successful exploit could allow the attacker to cause the device to reload, resulting in a DoS condition.

A vulnerability in the Layer 2 Tunneling Protocol (L2TP) feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to improper handling of certain L2TP packets. An attacker could exploit this vulnerability by sending crafted L2TP packets to an affected device. A successful exploit could allow the attacker to cause the device to reload unexpectedly, resulting in a DoS condition. Note: Only traffic directed to the affected system can be used to exploit this vulnerability.

A vulnerability in the Multicast Leaf Recycle Elimination (mLRE) feature of Cisco IOS XE Software for Cisco ASR 1000 Series Aggregation Services Routers could allow an unauthenticated, remote attacker to cause the affected device to reload, resulting in a denial of service (DoS) condition. This vulnerability is due to incorrect handling of certain IPv6 multicast packets when they are fanned out more than seven times on an affected device. An attacker could exploit this vulnerability by sending a specific IPv6 multicast or IPv6 multicast VPN (MVPNv6) packet through the affected device. A successful exploit could allow the attacker to cause a reload of the affected device, resulting in a DoS condition.

A vulnerability in the IP packet processing of Cisco Access Point (AP) Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient input validation of certain IPv4 packets. An attacker could exploit this vulnerability by sending a crafted IPv4 packet either to or through an affected device. A successful exploit could allow the attacker to cause an affected device to reload unexpectedly, resulting in a DoS condition. To successfully exploit this vulnerability, the attacker does not need to be associated with the affected AP. This vulnerability cannot be exploited by sending IPv6 packets.

A vulnerability in the DHCP Snooping feature of Cisco IOS XE Software on Software-Defined Access (SD-Access) fabric edge nodes could allow an unauthenticated, remote attacker to cause high CPU utilization on an affected device, resulting in a denial of service (DoS) condition that requires a manual reload to recover. This vulnerability is due to improper handling of IPv4 DHCP packets. An attacker could exploit this vulnerability by sending certain IPv4 DHCP packets to an affected device. A successful exploit could allow the attacker to cause the device to exhaust CPU resources and stop processing traffic, resulting in a DoS condition that requires a manual reload to recover.

Cisco IOS Software and IOS XE Software Extensible Messaging Client Protocol Denial of Service Vulnerability

A vulnerability in the Protocol Independent Multicast (PIM) feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a denial of service (DoS) condition on an affected device. This vulnerability is due to insufficient validation of received IPv4 PIMv2 packets. An attacker could exploit this vulnerability by sending a crafted PIMv2 packet to a PIM-enabled interface on an affected device. A successful exploit could allow the attacker to cause an affected device to reload, resulting in a DoS condition. Note: This vulnerability can be exploited with either an IPv4 multicast or unicast packet.

A vulnerability in the DHCP snooping security feature of Cisco IOS XE Software could allow an unauthenticated, remote attacker to cause a full interface queue wedge, which could result in a denial of service (DoS) condition. This vulnerability is due to improper handling of DHCP request packets. An attacker could exploit this vulnerability by sending DHCP request packets to an affected device. A successful exploit could allow the attacker to cause packets to wedge in the queue, creating a DoS condition for downstream devices of the affected system and requiring that the system restart to drain the queue. Note: This vulnerability can be exploited with either unicast or broadcast DHCP packets on a VLAN that does not have DHCP snooping enabled.

Cisco IOS, IOS XE and IOS XR Software TWAMP Denial of Service Vulnerability

Cisco IOS XE Software Security Hardening Release

Cisco IOS XE Software Security Hardening Release

Cisco IOS XE Software Security Hardening Release

Cisco IOS XE Software Security Hardening Release

Cisco IOS XE Software Security Hardening Release

Cisco IOx for IOS XE Software Command Injection Vulnerability

Cisco IOS XE Software Web UI OS Command Injection Vulnerability